In the multivark paste carbonara is not less delicious than on the stove!

Ingredients

Spaghetti – 150 g

Cheese hard – 40 g

Cream 15% – 70 ml

Salt and pepper – to taste

Bacon – 150 g

Green onions – 2-3 stems

Dried garlic – 2-3 pinch

Yolk chicken – 1 pc.

Vegetable oil – 1 tsp.

  • 368 kCal
  • 20 minutes.

Cooking process

Pasta carbonara in the multivark – it’s tasty, quick and easy. To someone who does not believe, I propose to make sure of this with my own hand by preparing this popular dish in my kitchen. You will need a minimum of ingredients. If you do not have bacon available, then replace it with ham or smoked meat, parmesan – any hard cheese, cream – fatty milk. Just do not prepare carbonate with cream fat content above 35%, as they turn into fat when heated.

Use a paste made from durum wheat if possible. Vegetable oil for frying can be replaced with creamy. By the way, such a dish can be served for breakfast, and for lunch, and for dinner, that’s only in the first two methods it is better to do without the addition of garlic.

So, prepare the necessary products for the carbonara paste and start cooking!

Ingredients for the carbonara paste in the multivariate

Activate the multicasting display on the “Varka” or “Soup” mode, pour into the bowl about 0.5-0.7 liters of hot water and bring it to a boil, turning on about 15 minutes. As soon as the water boils, place spaghetti in the bowl. Boil for 6-8 minutes.

  Pasta med skinke i cremet sauce

Put the pasta in the multi-

At this time, cut the bacon into cubes, and grate the cheese on a grater with small holes.

Grate the cheese and cut the bacon

In the bowl, combine cream with 15% fat, chicken yolk and grated cheese.

Connect the cream, yolk and cheese

Carefully dry the contents of the bowl, salt and pepper, add the dried garlic and mix again.

Pour in salt and pepper

Once the spaghetti is cooked, remove them from the liquid on the plate. Empty the liquid and rinse the bowl. Pour the sliced ​​bacon into it, pour in the vegetable oil, activate the “Frying” mode on the display for 5 minutes. Fry the bacon for about 2-3 minutes. If you use a onion, then fry it sliced ​​at the same stage with bacon.

Fry the bacon

Then add the boiled spaghetti into the bowl and mix.

Put the bacon to the pasta

Add the creamy sauce, stir and mash the carbonara paste in the multivark until the beep is about 1 minute.

Put the sauce

Then place the dish on the plates, sprinkle with finely grated cheese, chopped green onions.

Photo of carbonara paste in multivark

Immediately submit to the table.

Recipe for carbonara paste in multivark

Pleasant to you!

Carbonara paste in multivark